This section describes the hardware, software, and license requirements for FTD devices in a High Availability configuration.īe the same model. High availability is not supported on Firepower Threat Defense Virtual running in the public cloud. Monitored to determine if specific failover conditions are met. Occurs, the active unit fails over to the standby unit, which then becomesĪctive unit (hardware, interfaces, software, and environmental status) is The standby unit does not actively pass traffic, but synchronizesĬonfiguration and other state information from the active unit. Supports Active/Standby failover, where one unit is the active unit and passes The following topics describe how to configure Active/Standby failover to accomplish high availability of the FTD.Ĭonfiguring high availability, also called failover, requiresĭevices connected to each other through a dedicated failover link and, Separate Units in a High Availability Pair.Replace a Secondary FTD HA Unit with no Backup.Replace a Primary FTD HA Unit with no Backup.Replace a Unit in an FTD High Availability Pair.Refresh Node Status in a Firepower Threat Defense High Availability Pair. Switch the Active Peer in a Firepower Threat Defense High Availability Pair.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |